7662 questions

9091 answers

14654 comments

12052 members

0 votes
428 views 1 comments
by
New router on first firmware update. Everything went normally until there was power cut of (on house level). Router rebooted, reset to factory settings etc. All 5 Signal lights are on, occasionally the "2G, 3G,4G" lights are turning on at same time. No access to router with LAN line.

What to do?

1 Answer

0 votes
by

Try following this instruction: https://wiki.teltonika.lt/view/RUT2xx_Firmware_via_The_Bootloader_Menu

If it does not help you should contact your reseller 

by
Hi, Thank you of the answer. I have tried bootloader, but the problem is that I can't get the router to the "bootloader mode". I understood that WAN and LAN lights should be blinking in that mode.

In other words the router is not receiving the firmware update.