5654 questions

6864 answers

11066 comments

6945 members

0 votes
445 views 7 comments
by
I have a RUT955 and use Zerotier to connect to it. The IP given from ISP is not useable for remote access. Now i want to connect to two Raspberry PI behind the router. I have tried different settings for NAT but nothing works. The setting i like are to port 8181 to port 80 to IP on local lan, and 2244 to port 22 also on IP on local lan.

Please give me an example how to do this if possible.

1 Answer

0 votes
by

Hello, 

Regarding the question of yours here is how you will do it on the port-forwarding scenario. 

1. Create a port-forwarding rule for 8181 to 80 to the RASP PI LAN IP. 
2. Click Edit as show as below:

3. After that you must configure the source zone and internal zone. 


You can do the same for the SSH access. 

Take note: The Laptop/PC must be also in your zerotier network where the router is connected to. 

Hope it helps

Regards,
Jerome

by
I have done this and it wont work.
by
Is the laptop you are using is also connected to your zerotier network??

Could you share me a screenshot of your zerotier config? Because on my side it is working fine.

Regards,
Jerome
by
I get connection refused. Port 8181 never opens if i check with nmap.
by
Hello,

As what was discussed i will be consulting our HQ for the issue you are having.

Regards,
Jerome
by
What page of the Zerotier config do you like to see?

And ofcourse my computer is on zerotier network, otherwise i couldnt remote access the router. :D
by
Kindly check your inbox.

Regards,
Jerome
by

Tried with ssh. Connection refused.