Question

Hi,

I would like to turn on an LED (in best case an RGB LED) by setting a specific output pin.

How can I achieve this ? Do I need a second power source only for the LED?

For example: I would like to have a yellow LED light up when the system is running and a green LED when the LTE connection is established. How is this possible?

Thank you very much!

Answer 1

Hi,

Everything about input and outputs can be found here: https://wiki.teltonika-networks.com/view/RUT955_Input/Output

Including wiring and configuring them.

As for LEDs, I'll assume your LEDs have more colors than yellow and green so it would mean there are also more states on the controller of it, and that could be problematic as our I/O can only give out two states, 1 or 0.

So I'm afraid you will have to figure it out yourself.

EB.