6386 questions

7717 answers

12532 comments

8400 members

0 votes
75 views 6 comments
by
The RUT240 is used as WIFI to WIFI Router. For Public WIFI Network I try to use WireGuard for VPN.

Ther is WireGuard VPN setup > Services > VPN > WireGuard.

I get the message >There are no WireGuard configurations yet<

?????

2 Answers

0 votes
by
Hello,

Could you provide more information about your issue? First, which firmware version your device is using? Have you rebooted your router after Wireguard install? Have you tried to configure it already? Also, attach a screenshot of the Wireguard page.

Regards.
by
Hello,

the System FW is RUT2XX_R_00.01.14

How can i attach screenshots ???

regards
0 votes
by

Hello,

the System FW is RUT2XX_R_00.01.14



regards

by

I have marked a tool that allows you to upload screenshots

by
Hello,

after reset and reinstallation everything runs smoothly,

regards
by
Hello,

I must recant the statement I made earlier.
At first everything ran ok, then I changed the WIFI STA connection.

After that was the same error message as previously described.

Also a reboot leads to no success.

Regards
by
Hello,

Could you provide steps on how you were able to reproduce this issue? Please describe everything step by step. I will try to reproduce it myself.

Regards.
by
Hello,

After the hardware reset I changed the AP to my liking. Then I configured the STA to connect to my home WIFI.
Subsequently, I have set up the Wireguard VPN.
This was immediately active.
Since I want to use the router in my caravan, I have to constantly change the WIFI network when traveling.
After changing the STA, the VPN configuration was not displayed under Status > Wireguard and no VPN was established.

Regards