8394 questions

9874 answers

15660 comments

14147 members

0 votes
56 views 0 comments
by

Hi

None of the forum replies specifically addresses my configuration.

My settings are (as far I can see and compare with other configuration screenshots) as they should be for Wireless WAN, but it does not work.

Traffic continues to go through 4G LTE connection.

Below is my configuration (note my RUT IP addresses in case this is a problem)

Diagram of setup

Screenshots of WiFi WAN settings

Maybe it is that I do not have a WAN cable connection?

Maybe there is a way to 'MAP' the Wireless Client to the WAN interface?

Thanks!!

Colin

----------------------------

Diagram of system. NOTE: There is no cable in the RUT WAN connection

I want Wireless_Wan connection to be primary WAN

Here are my Network Interfaces (LAN, Wireless and 4G only)

Here are my Failover Settings Wireless_Wan is at the top

My Wireless_Lan interface

Settings for Wireless_Lan

1 Answer

0 votes
by
Hello,

Thank you for contacting.

I see that you are using 7.00 fw version. It needs some major updates and yes some of the functionalities would not work properly. So, it is recommended to downgrade device firmware to 6.08.3 .

Thanks.

Regards,

Ahmed