FOR TIPS, gUIDES & TUTORIALS

subscribe to our Youtube

GO TO YOUTUBE

14455 questions

17168 answers

28195 comments

0 members

We are migrating to our new platform at https://community.teltonika.lt. Moving forward, you can continue discussions on this new platform. This current platform will be temporarily maintained for reference purposes.
0 votes
249 views 1 comments
by anonymous
Hello,

I have a RUT955 and i am attempting to get the status of my Onboard IO in my Command Line.

I have followed the "Status from Command Line" documentation (picture attached) but I am getting "Command Failed: Not Found" when attempting to run "ubus call ioman.gpio.din1 status" or that same command for any of the Onboard IO (pic attached)

Any ideas on why this is happening?

1 Answer

0 votes
by anonymous
Hi,

We don't see attached pictures yet, can you repeat? Also specify which firmware version the RUT955 is running?

Regards.
by anonymous
I actually found the issue. I was running a previous firmware revision. The previous revision did not allow me to run io commands. After updating it was resolved. I can not remember the exact firmware I was running initially sorry.