WIKIABOUT

FOR TIPS, gUIDES & TUTORIALS

subscribe to our Youtube

GO TO YOUTUBE

14455 questions

17168 answers

28195 comments

0 members

Most popular tags

rut955 rut240 rut950 rutx11 rms vpn to openvpn wifi not sms trb140 firmware connection - ipsec on rutx12 rutx09 modbus
We are migrating to our new platform at https://community.teltonika.lt. Moving forward, you can continue discussions on this new platform. This current platform will be temporarily maintained for reference purposes.

Modem partial control not accepting AT commands

0 votes
311 views 1 comments
by anonymous

My TRB142 doesn't accept any input when configured as a modem in partial control. I'm only getting the +QCSQ status messages every few seconds.

It says that it should support AT commands, but it seems like it doesn't:

  • Partial Control- Enables Modem Control With AT Commands, Mobile Connection Will Be Controlled By RUTOS.

1 Answer

0 votes
by anonymous

Hello,

Please note that after testing the above issue, it seems to be working in the latest FW 7.1.2.

Kindly upgrade your FW to the same.

https://wiki.teltonika-networks.com/view/TRB142_Firmware_Downloads

Hope this resolves the issue.

Regards,

Clive Simon Victor Pinto

by anonymous

I have the latest FW 00.07.02 and in partial mode, AT commands are only accepted if the line ends with CR+LF characters (not just CR like in full mode and what most other modems accept). Maybe this is also the original poster's problem.

For this reason I can't use partial mode as our embedded device only sends CR as endline.