FOR TIPS, gUIDES & TUTORIALS

subscribe to our Youtube

GO TO YOUTUBE

12016 questions

14300 answers

22542 comments

35968 members

0 votes
100 views 0 comments
by
Hi,

When connected to my VPN supplier using a Wireguard connection everything seems to work fine as long as I use the WAN (ethernet) connection. If I unplug the ethernet cable the router switch to the mobile connection (4G) as expected according to my failover settings. Still everything seems ok. But when I put the ethernet cable back into the router the mobile connection is still active and the traffic continues to use that connection instead of going back to the WAN connection.

In the log I can see that the router is switching back to the WAN connection but the traffic is still using the mobile connection.

If I disable the VPN connection the failover is working as expected.

What am I doing wrong here?

Br,

Henrik

1 Answer

0 votes
by

Hello,

Could you try to enable "Flush connections on" setting in your failover configuration for both mobile and wired WAN interfaces? Example attached:

Best regards.