I have configured my RUT950 to use Wireless as the WAN , however when it connects to the Wireless Access point all RUT950 clients lose connectivity
The Link stays active however the IP address of the RUT950 LAN network no longer responds
I enabled remote access and in the status the LAN is still stated as present with its IP address however there are no DHCP clients listed . Refreshing the DHCP on the client fails
The configuration I changed was to select Main WAN on the wireless link and then add the correct SSID in the configuration under Wireless station mode - when I applied the changes I could see the RUT950 had succesful connected to the AP - but all local clients had lost connection
Am I missing something such as a VLAN change or something that is required
I believed I asked this question yesterday however as I have no questions listed under my account I am attempting to resubmit
I am using RUT9XX_R_00.06.08.6 - Some other forum post seem to indicate the non-Legacy interface does not support configuration of the WAN to use Wireless