10456 questions

12462 answers

19387 comments

21897 members

0 votes
60 views 0 comments
by
I have a few Rut240's setup successfully on a site, and I need to add another Rut240 into the mix.

When I configure the local Rut everything is fine, but if I remotely access any of the onsite Rut's via RMS, when I put in the Wireguard settings for the new Rut, and click apply, it just sits there, I have tried multiple browsers and also different site Rut's, all the same

Has anyone seen this before and have a solution please?

1 Answer

0 votes
by
Hello,

Is the issue still relevant?

What firmware version is your device using?

Best regards,

Žygimantas