FOR TIPS, gUIDES & TUTORIALS

subscribe to our Youtube

GO TO YOUTUBE

14455 questions

17168 answers

28195 comments

0 members

We are migrating to our new platform at https://community.teltonika.lt. Moving forward, you can continue discussions on this new platform. This current platform will be temporarily maintained for reference purposes.
0 votes
830 views 1 comments
by anonymous
Hi,

please, give me an advice. I have TBR140 and one iOt device connected to eth0. These device supported only 100Mbps speed, so i try to manualy edit eth port via CLI with these command: ethtool -s eth0 speed 100 duplex full autoneg on

After i run these command, iOt device work fine, but after restart, i must manually run command again.

So i try write these command to startup custom scripts via GUI, but is not work. Please, is another way to manualy set speed to ethernet port, or some tips to write it on custom scripts?

Thanks!

1 Answer

0 votes
by anonymous

Hello,

Please follow this Wiki guide to learn about start-up scripts execution: https://wiki.teltonika-networks.com/view/RUT955_Custom_Scripts#Startup_Script

Regards.

by anonymous

Hi, many thanks for your response. But when I paste command to web interface, it doesnt work. See "CustomScript - photo" please.

Thanks!

CustomScript - photo