FOR TIPS, gUIDES & TUTORIALS

subscribe to our Youtube

GO TO YOUTUBE

12689 questions

15068 answers

24147 comments

47137 members

0 votes
64 views 2 comments
by
Hello,

I am testing RUT360, firmware 7.2.7, and it takes very long to connect to Internet if failover is activated.

Surprisingly, it behaves normally if failover interfaces are switched off.

Could this be a bug?

Thank you

1 Answer

0 votes
by
Hello,

How long is “very long“?

Is it mobile that takes a long tome to establish connectivity?

Could you share your failover configuration settings?

Best regards,
by
Hello,

Thank you for your answer.

Very long means at least 10 minutes, up to 15 minutes, while the same device with previous versions was about 2 minutes from power on.

Failover is by default on special configuration: Failover activated, priority to Ethernet port.

If I disable failover, it is fast again.

Best regards,
by
I was unable to replicate the issue.

It would be helpful if you could recreate your scenario and generate the troubleshoot where it would be visible that failover occurs after a lengthy interval.