Question

My current network topology is:

Fibre Modem > Meraki Go Router > Meraki Go Switch

I want to introduce the RUT950 (with a sim in bay 1) into this topology to act as a failover should the fibre signal from the modem fail.

My thoughts are that I could put the RUT950 here:

Fibre Modem > RUT950 > Meraki Go Router > Meraki Go Switch

Is this correct? And if so how do I configure the RUT950 to work here?

Thanks

Answer 1

Hello,

Thank you for contacting Teltonika Networks Crowd community.

The set up is correct. The WAN cable from the Fiber Modem will go to the RUT950 WAN interface. Then set the Failover on RUT950.

Check the following link on how to configure RUT950 Failover https://wiki.teltonika-networks.com/view/RUT950_Failover

Kind regards,

Shadrack.