WIKIABOUT

FOR TIPS, gUIDES & TUTORIALS

subscribe to our Youtube

GO TO YOUTUBE

14455 questions

17168 answers

28195 comments

0 members

Most popular tags

rut955 rut240 rut950 rutx11 rms vpn to openvpn wifi not sms trb140 firmware connection - ipsec on rutx12 rutx09 modbus
We are migrating to our new platform at https://community.teltonika.lt. Moving forward, you can continue discussions on this new platform. This current platform will be temporarily maintained for reference purposes.

Remote access to LAN devices from WAN in the RUT240

0 votes
495 views 0 comments
by anonymous
Hello,

I apologize in advance if this question has been asked previously, however I'm unable to determine the correct setup and have tried numerous settings to get this to work. I am trying to allow web and telnet access to a LAN side device with both Telnet and HTTP(S) from the WAN. My LAN device has a static IP of 192.168.1.5 and I've used RMS and created those connections through RMS connect but they never do connect. I have also gone into the web interface of the RUT240 via the Device Web UI and created port forwarding rules but can't seem to make it work. Any help is appreciated.

Regards

1 Answer

0 votes
by anonymous

Hello,

Please check the videos below:

Remote HTTP(S) access: https://www.youtube.com/watch?v=83cg9oKMm2E

Remote Telnet: https://www.youtube.com/watch?v=-Syav3rcfec 

RMS VPN HUB: https://www.youtube.com/watch?v=dfAudZR2wPY

Keep in mind that Auto scan feature might not detect your device and you may need to configure it manually.

As for port forwarding, you must have a Public IP and that might not be your case.

Also, if you have set up a static IP for the local device, make sure it has a gateway address of RUT240 LAN IP.

Best regards,