Hello,
Thank you for reaching out!
I believe the solution you're trying to achieve could be done using the ubus commands. For RUTX09, possible values for dout1 (digital output) can be found by running a command:
ubus -v list ioman.gpio.dout1
To change the status of digital output, a command like this should be used:
ubus call ioman.gpio.dout1 update '{"value":"1"}' (to enable the output)
or
ubus call ioman.gpio.dout1 update '{"value":"0"}' (to disable the output)
Status can be read using this command:
ubus call ioman.gpio.dout1 status
These are basically the same commands as the HTTP method passes to the ubus. The same commands can be used for input configuration.
If you're looking for something different, let me know and I'll investigate further.
Best regards,
DaumantasG