WIKIABOUT

FOR TIPS, gUIDES & TUTORIALS

subscribe to our Youtube

GO TO YOUTUBE

14455 questions

17168 answers

28195 comments

0 members

Most popular tags

rut955 rut240 rut950 rutx11 rms vpn to openvpn wifi not sms trb140 firmware connection - ipsec on rutx12 rutx09 modbus
We are migrating to our new platform at https://community.teltonika.lt. Moving forward, you can continue discussions on this new platform. This current platform will be temporarily maintained for reference purposes.

WAN as LAN doesn't work - device is not detected

0 votes
332 views 1 comments
by anonymous

Hello,
I'm trying to configure WAN port as LAN on newest firmware of the RUT240 (RUT2_R_00.07.03.3). I seen many posts on the forum but nothing really helps, I also checked wiki: https://wiki.teltonika-networks.com/view/Setting_up_WAN_as_LAN. I'm checking the WAN config by switching ethernet cable from LAN and trying to recconect to the router. 
Is there anything else with I should setup to make it work?
 

1 Answer

0 votes
by anonymous

Hello,

The attached troubleshoot file indicates incorrect configuration.

You have physical eth0 interface assigned to WAN in Network -> Interfaces page. 

The opposite has to be done. Remove eth0 from Network -> Interfaces -> WAN -> Physical settings tab and add eth1 to Network -> Interfaces -> LAN -> Physical settings.

Also, there is no indication that WAN and WAN6 interfaces are disabled. Can you confirm that they are set to off?

Best regards,

Best answer
by anonymous
Thank You very much, as You said I did the opposite adding interface eth0 to the WAN. Also WAN6 interface wasn't disabled. After fixes everything works.
Regards Konrad