Question

Hello,

I disabled the LAN and couldn't connect wit WebUI.

So i did a factaory reset with the reset button on the device.

It works, because my computer get's an internet ocnnection, but the login page is gone. So i can't login and manage my device.

I did read this article https://community.teltonika-networks.com/59651/rut240-after-firmware-update-login-possible-error-failed-load

But i don't know the downgrade command for this TRB145 device.

TS file is attached

Can anyone help me?

Answer 1

Hello,

I assume the troubleshoot file was generated via SSH.

Have you tried using browser's private mode, a different browser or clearing the cache?

Could you reset the device with the following CLI/SSH with commands:

• firstboot
• reboot

You could try downloading the latest firmware (here) for your device, upload it using WinSCP to router's /tmp directory and perform update with the command below:

• sysupgrade /tmp/TRB1_R_00.07.03.2_WEBUI.bin

Also, does your computer actually get internet access, because the troubleshoot file shows that device was not registered to any operator and was disconnected at the time the file was generated?

Best regards,

Comments

Thank you  ZygimantasBliu

Private webpage did work. 

I connected the TRB145 to a different computer to generate the SSH file. I didn't connect the antenna in that setup. 

No it's time to configure it again. Hopefully i don't need your help anymore.

Cheers! Joeri