FOR TIPS, gUIDES & TUTORIALS

subscribe to our Youtube

GO TO YOUTUBE

14455 questions

17168 answers

28195 comments

0 members

We are migrating to our new platform at https://community.teltonika.lt. Moving forward, you can continue discussions on this new platform. This current platform will be temporarily maintained for reference purposes.
0 votes
165 views 0 comments
by anonymous
Good afternoon,

I would like you ask about help.

I need set 100MBit/Full Duplex configuration on my WAN Interface RUTX-11 - S/N 1108360646, FW 00.07.02.6. As I know from WIKI, it's possible also in WebUI, but in my configuration page Network-Interfaces-WAN -Physical Settings is'nt offer Speed/FullDuplex.

Where I did a mistake, please?

Thank you in advance

Vladimir

1 Answer

0 votes
by anonymous

Hello,

Could you login to the router via CLI/SSH and execute the following command:

  • ethtool -s eth1 duplex full speed 100 autoneg off
Then, to check the configuration for the port, simply enter:
  • ethtool eth1

Best regards,