FOR TIPS, gUIDES & TUTORIALS

subscribe to our Youtube

GO TO YOUTUBE

14455 questions

17168 answers

28195 comments

0 members

We are migrating to our new platform at https://community.teltonika.lt. Moving forward, you can continue discussions on this new platform. This current platform will be temporarily maintained for reference purposes.
0 votes
70 views 0 comments
by anonymous
why does the RS485 serial port on some RUT955 routers work fine without the need to turn "raw mode" on, but on other RUT955 routers the data that goes through the RS485 gets corrupted or modified if the "raw mode" is not turned on? An example of the corruption without "raw mode" is that "CR LF" gets changed into "LF LF", or ETX bytes (#03) get filtered out of the stream

1 Answer

0 votes
by anonymous

Hello,

Different routers might have different RS485 controllers.

Could you check, if there is a difference between devices hardware revision in router's WebUI System -> Status page or device batches?

Also, do all devices use the same firmware version?

Could you check, if adding a small, let's say 10 - 50ms serial device read time, resolve the issue?

Best regards,