Hi, I installed a TRB140 and want to use it with two network-interfaces:
The USB-Port should stay as LAN and should be used from a FritzBox als LTE-failover with a dchp-Network.
The LAN-Port I want to use in the FritzBox LAN to access the LAN without the FritzBox.
I do these steps:
Go to Interfaces and remove eth0 from the LAN-interface.
Create a LAN2 Interface
And then I want to add the physical eth0 to these LAN2 - but there is only rndis0 available (the usd).
While trying I recognize to enter eth0 and it's working fine - but should the UI not show the eth0 to select?