Question

I am using the RUTX10 in a test setup and is configuring both 2.4GHz and 5GHz radios in STA mode. They connect to two different APs. This all works fine when I first set it up. But if I reboot the device or loose the link to the APs, autoreconnect is not stable. It is very often the case that the 5GHz reconnect but the 2.4GHz never reconnects. Is there a workaround for this issue or is this configuration hard to handle with a RUTX10.

Answer 1

Hello,

Tested with the latest FW: https://wiki.teltonika-networks.com/view/RUTX10_Firmware_Downloads everything works fine. After the reboot device connects both to 2,4 and 5 GHz WiFi.

Make sure all the devices are using WiFi antennas and also try moving 5 Ghz AP closer to RUTX10, because 5 Ghz has shorter range then 2,4 Ghz WiFi.