Question

When we set LAN interface as wired WAN, there will be twor wired WAN,

Is these two wired WAN will work when put on load balancing policy ?

Comments

I have the same question - but this does not seem to be resolved?

Answer 1

Hi,

May I ask which device are you trying to configure?

EB.

Comments

Hi EB,

I'm trying to confugire RUT950

Hafid.

---

I have enabled a LAN interface as wired WAN, then i have additinal WAN but there is no interface name on new WAN.

When i go load balancing policy, the new WAN i configured is not shown on dropdown at WAN selection.

Any idea ?

Hafid

---

Hi,

https://wiki.teltonika-networks.com/view/RUT950_Use_LAN_port_as_WAN

Please follow these wiki page instructions which are meant for LAN as WAN and Failover configuration, but also please follow these notes:

• Set all of your routers in different subnets, e.g 192.168.1.1 192.168.2.1 and 192.168.3.1
• Once you're at editing network config with vi, fully copy wired (eth1) wan configuration and make sure your new wan interface is using eth0.1.
• Once you're done with wiki guidelines - go to your network adapters on PC and edit network adapter that is connected to your new 2 wan configured router (e.g 192.168.3.1) . Make sure it has DNS server configured to 192.168.3.1.