FOR TIPS, gUIDES & TUTORIALS

subscribe to our Youtube

GO TO YOUTUBE

14455 questions

17168 answers

28195 comments

0 members

We are migrating to our new platform at https://community.teltonika.lt. Moving forward, you can continue discussions on this new platform. This current platform will be temporarily maintained for reference purposes.
0 votes
587 views 0 comments
by
Hi

We where recommend to buy a RUTX10 to function as a wireless bridge for some equipment we have that doesnt support wifi.

Wifi is setup as client mode, and we have enabled relayed on the LAN port (disabled DHCP) - but no traffice is flowing - and the status on the interface called WWAN is stopped ? What are we missing here ?

The documentation found here :   https://wiki.teltonika-networks.com/view/Relayd#WiFi_WAN  ( way outdated )

Firmware version :

RUTX_R_00.02.05.2

1 Answer

0 votes
by anonymous

Hello,

I have just tested Relay feature myself and everything worked as expected. Detailed steps:

  • Connected to a WiFi source as a client.
  • Checked if I can access the internet from router CLI (ping google.com)
  • Navigated Network > Interfaces > LAN
  • Disabled DHCP and Enabled Relay. Also selected WWAN interface below enable slider. Save and Apply.

WWAN interface was up as before and my PC connected via LAN cable obtained IP from wireless interface.

I would suggest double-checking your steps, also you are using an older firmware version (update to RUTX_R_00.02.06), check if WiFi source is reliable and connected to the RUTX10 before relay configuration.

Also, that documentation is not outdated. It is an example on how to enable Relay feature in RUT9 devices.

Best regards.