Question

Based on the youtube video, I created two guest account on why router RUTX11. Please see below the settings. Wifi_Guest2.4GHz is working fine, but the Wifi_Guest5GHz is not. I was wondering whether different destination ports must be selected or not. Please advise

Wifi_Guest: 2.4GHz: WPA_PSK encryption: PW: (unique password)

General setup: Mode: access point; ESSID: Guest_wifi2.4GHz_W10.20; network: Guest;

Firewall general setting: Guest_zone>WAN: (input) accept, (output) accept, (Forward) reject;

Firewall Traffic Rules: Source zone: Guest zone: Wifi_Guest, Guest; Destination zone: device; Destination port 20 80 443; Action: Reject

Wifi_Guest: 5GHz: WPA_PSK encryption: PW: (unique password)

General setup: Mode: access point; ESSID: Guest_wifi5GHz_W10.20; network: Wifi_Guest;

Firewall general setting: Guest_zone>WAN: (input) accept, (output) accept, (Forward) reject;

Firewall Traffic Rules: Source zone: Guest zone: Wifi_Guest, Guest; Destination zone: device; Destination port 20 80 443; Action: Reject

Best,

Jules

Answer 1

Hello,

Thank you for contacting us. 

I have tested it on my side , setup a wired WAN , then created two wifi 2.4Ghz and 5Ghz . 

Everything worked fine without any issues. 

I have tested it on latest firmware .

Its best to upgrade device to the latest firmware. 

If you are already using the latest firmware its best to re-flash the firmware without keeping settings and try again. 

Might be some misconfigurations are causing the issue. 

Thank you.

Regards,

Ahmed

Comments

And both are working on the same destination port?