Question

When connected via RMS, when I change hot spot landing page settings, when click Save, it is not saved.

It get back to default values.

When connected via LAN, then changes get saved .

Answer 1

Hello,

Could you specify which router are you using and the firmware version ?

Comments

rut950, 00.06.00.04 , latest firmware

---

This is the step order:

1. Updated firmware to latest , 00.06.00.4

2. Then did factory reset (because hot spot another problem).

3. Connected via RMS to once again setup Hot spot

But you cannot do that, it seems that Landing page in this situtation is read-only. When I log in via LAN, then landing page can be set up.

---

Hi,

RND is informed about the issue. I'll let you know when I'll have the feedback.

---

Now with 00.06.02, it is almost ok.

It reports error on Save, but just when you try to save "Logo Image Configuration" uploaded.

Else works on Save.

Answer 2

Hi,

I have tested the scenario you described with the latest firmware 00.06.00.04 and it seems to work fine. Have you tried resetting the router to default settings and reconfigure?

Comments

Yes, I did ( step 2).

Have you tried reseting to default after update to latest firmware?