WIKIABOUT

FOR TIPS, gUIDES & TUTORIALS

subscribe to our Youtube

GO TO YOUTUBE

14455 questions

17168 answers

28195 comments

0 members

Most popular tags

rut955 rut240 rut950 rutx11 rms vpn to openvpn wifi not sms trb140 firmware connection - ipsec on rutx12 rutx09 modbus
We are migrating to our new platform at https://community.teltonika.lt. Moving forward, you can continue discussions on this new platform. This current platform will be temporarily maintained for reference purposes.

RUTX11 How reconnect to WWAN when back in range?

0 votes
121 views 0 comments
by anonymous
I have WWAN and Mobile connections, with WWAN being the priority. If the WWAN goes down, the router Failovers to Mobile. But when WWAN comes back up again, it stays on Mobile. When I check the Interfaces it shows WWAN as 'Stopped' and when I check Wireless it also shows 'Stopped' - see attached. Within the Failover settings for WWAN I have switched on 'Flush connections on' both 'Connected' and 'Disconnected'. How can I get it to switch back to WWAN once it is available again? Thanks

1 Answer

0 votes
by anonymous

Hello,

Thanks for contacting TELTONIKA | Crowd-support forum.

In order to set up the WWAN as the primary WAN connection, enter in your device’s WebUI, go to Network > Failover then drag & drop your WWAN interface into the head of the list.

More information can be found here:

https://wiki.teltonika-networks.com/view/RUTX11_Failover

Otherwise, it is recommended that you upgrade the router's Firmware whenever there is a new version.

Please try to upgrade the router’s firmware to latest one RUTX_R_00.07.01.2, without keep setting.

Firmware can be upgraded either from server or from an image uploaded from your computer.

More information can be found here:

https://wiki.teltonika-networks.com/view/RUTX11_Firmware_Downloads

https://wiki.teltonika-networks.com/view/RUTX11_Firmware#Update_Settings

https://www.youtube.com/watch?v=ZWhp_njlXdY

Best regards,