Question

Hi

I am setting up a RUT955 as an Ntrip Client. I have installed software version RUT9XX_R_00.06.09.2.

I have attached a picture of my setup. I can't get it to log in to my Ntrip server.

Have connected HyperTerminal, where I can see that my GPS receiver is sending out GGA messages. But as soon as I connect it to the Rut955 Rs232, the GGA message stops being sent out, it just freezes. and does not progress.

I have tried with different baud rates, and checked that my receiver sends out the same thing. Tried with 1HZ, 5HZ and 10HZ GGA Message.

Do you have any idea what could be wrong?

Answer 1

Hello,

Could you check the serial settings, specifically the baud rate? As, based on the screenshots you have provided, they do not seem to match.

Best regards,