FOR TIPS, gUIDES & TUTORIALS

subscribe to our Youtube

GO TO YOUTUBE

14455 questions

17168 answers

28195 comments

0 members

We are migrating to our new platform at https://community.teltonika.lt. Moving forward, you can continue discussions on this new platform. This current platform will be temporarily maintained for reference purposes.
0 votes
110 views 1 comments
by anonymous
Hi,

We have observed a change in newer RUTX11 (hardware revision 1010)

During startup the GPIO output collector is enabled for ~8 seconds then goes back to floating (the default we have configured it to).

A previous version of the RUTX11 we have with hardware revision 0808 does not behave the same way, the output remains floating through the whole startup.

Any changes between these revisions that would cause that?

Thanks

1 Answer

0 votes
by anonymous
Hello,

Thank you for this observation. I have forwarded your question for the development team to provide further comments on the issue. Once there are updates, I will post them.

Best regards,
by anonymous

Hello,

Developers have provided a firmware solution. You can download it from here: https://kaunas.teltonika.lt:444/f/d5d44d7a977942819e14/

Keep in mind that this is a test version, meaning that some other functionalities may not operate properly. 

It would be really helpful to receive feedback from you.

Best regards,