7644 questions

9073 answers

14631 comments

12005 members

0 votes
26 views 0 comments
by

I am trying to connect  TRM240 to a FritzBox router for 4g failover. However the router does not recognize the TRM240 as a mobile broadband device via AT commands. I have received the following from AVM support:

In the provided support file, we find that your Teltonika dongle does not reveal itself as a mobile broadband device:
<!--[if !supportLineBreakNewLine]-->
<!--[endif]-->

04.06.21 09:54:37 A non-supported USB device has been connected.

04.06.21 09:54:37 USB device 1003, class "USB 2.0 (hi-speed) bulk", plugged in

04.06.21 09:54:13 USB device 1002 unplugged


According to the manufacturer's site, this dongle requires specific Windows drivers. We therefore doubt whether the FRITZ!Box can communicate with it with standard AT commands.

Is it possible to configure the TRM240 for this mode? Any advice would be appreciated.

1 Answer

0 votes
by
Hi,

This method didn't work?:

https://en.avm.de/service/knowledgebase/dok/FRITZ-Box-7390-int/76_Setting-up-FRITZ-Box-for-internet-access-via-the-mobile-network/

If your Fritz!Box doesn't see the modem connected through USB it just means that it doesn't have the drivers to detect it automatically.

I'm not sure how it's done on Fritz!Box, so it's really hard to give you information that would be correct.

My best suggestion would be looking for libraries, third-party applications or software for fritz!box to establish modem detection through USB.

For example, these instructions helped to give out the IP to Raspberry PI:

https://www.embeddedpi.com/documentation/3g-4g-modems/raspberry-pi-sierra-wireless-mc7304-modem-qmi-interface-setup

EB.