FOR TIPS, gUIDES & TUTORIALS

subscribe to our Youtube

GO TO YOUTUBE

14455 questions

17168 answers

28195 comments

0 members

We are migrating to our new platform at https://community.teltonika.lt. Moving forward, you can continue discussions on this new platform. This current platform will be temporarily maintained for reference purposes.
+1 vote
275 views 2 comments
by anonymous

Hi,

trying to configure RUT240 for AzureIOT following instructions in https://community.teltonika-networks.com/?qa=blob&qa_blobid=6435639023607289995

At CLI, trying to run azure_iothub I get a segmentation fault.

This happens on two RUT240s, both look to be configured correctly, both on firmware RUT2XX_R_00.01.14.5

On a reboot of the devices, some azure messages are sent ... but then once the device has finished booting, I'm back to the segfault, and no azure messages are sent.

Any suggestions? Troubleshooting file is attached.

Thanks

Mark

by anonymous
Hallo

I have the extactly some issue.

Thanks

Michael

1 Answer

0 votes
by anonymous
Hello,

Based on the troubleshoot files you configured things on MQTT like Hive, thingsboard, and others. Just try to reset the device to its factory settings just to make sure everything is clean. After doing so just try to follow the same configuration that is shown in the document you shared.

If the issue still persists let me know.

Regards,

Jerome
by anonymous

Hi Jerome,

I am facing the same issue using Teltronica TRB245. I already reset the device to its factory settings but the issue continues. There is any available solution? 

Thanks in advance.

Regards,

Javiera