I intend to use an rutx10 with a wired wan and both 5ghz and 2.5ghz set to client mode as 2 separate wifi wan connections. All 3 of these wan sources are to be from the same router [rutx11 in router mode] , without going into detail it has to be like this for the location, offering security/redundancy for this bridge. The issue ive foreseen from my experience setting up failover on an rutx11, is that the load balancing seems tied into failover and cant be switched off without the unit asssuming the connections are all always live or something to that effect. Why is the firmware like this , another brand has a tripple wan network switch which , though they advise you to leave load balancing on , it can be switched off for simple failover/failback config. Sometimes simplicity is better , and even better is the option to switch between complex auto operation or simple settings in one product. How can the failover / failback be configured without load balancing at all ? I believe this will involve the "flush connections settings for each interface . Id like to be clear it can be set to totally refrain from trying to load balance between the wired wan , 5ghz,and 2.4ghz interfaces, as i expect issues based on my experience trying to set up the rutx11 .....[which has 4g as well]. Incidentally that should be able to be set as failover only but it keeps pinging through the sim at a min value of 1 which cant be set to 0, thats not good news if you have a pay as you go sim.I believe this pinging is called"keep alive" by other brands , but can be set to 0 / switched off. Has anyone else successfully configured this triple wan /failover from single router [source] and was this done using teltonika native system or open source software ?