10456 questions
12460 answers
19384 comments
21896 members
Hello,
Each device might have connectors with the differing number of pins. But the underlying pattern for the UART pinout is the same for all devices. The square pin is used for Tx on one side and Rx on the other. To illustrate, check the table.
RX
TX
-
HW_RST
GND
As a reference the picture is provided below.
Also, you can check these other threads:
https://community.teltonika-networks.com/42941/trb245-debug-port?show=42941#q42941.
https://community.teltonika-networks.com/42196/teltonika-trb142?show=42213#a42213.
Best regards,
Žygimantas