Question

Hello,

I am interested in using the internal UART port, is it possible to get the pinout, for models RUTx09, RUTx11 and RUT360?

Thank you

Answer 1

Hello,

Each device might have connectors with the differing number of pins. But the underlying pattern for the UART pinout is the same for all devices. The square pin is used for Tx on one side and Rx on the other. To illustrate, check the table.

RX	TX
-	HW_RST
-	GND

As a reference the picture is provided below.

Also, you can check these other threads:

https://community.teltonika-networks.com/42941/trb245-debug-port?show=42941#q42941.

https://community.teltonika-networks.com/42196/teltonika-trb142?show=42213#a42213.

Best regards,

Žygimantas

Comments

Do you have the reference of a mating connector that can be used or the only way is to solder wires ? And what is the voltage ?

Regards,

---

Thank you very much!

And the rest of the pins, are available for any use, like more GPIOs?

Anyway, the serial part was the one I was interested in.

Best regards