Question

Hi,

I was looking for an example to configure the rutx12 as a router on stick and I didn't found anything.

Is there a way to configure the rutx12 or a rut955 as a router on stick just to use 1 physical connection and send multiple vlans through it.

Thanks

Answer 1

Hello,

Login to the router's WebUI. The configuration is as follows.

• Navigate to Network -> VLAN -> Port based. Add the number of VLANs you need, set their IDs and select Tagged under a single port as in the example below:

• Next, navigate to Network -> Interfaces and add the same number of interfaces, as you have VLANs. In the General settings tab set protocol as Static, configure each interface in a different subnet, enable DHCP server.

• In the interface's Physical settings tab assign physical interfaces to VLANs.

• In the Firewall -> General settings -> Zones section, make sure VLANS are added to LAN zone.

From the routers perspective, this should be enough.

Best regards,

Comments

It worked. Thank you very much for the help and the quick response.