FOR TIPS, gUIDES & TUTORIALS

subscribe to our Youtube

GO TO YOUTUBE

14081 questions

16726 answers

27451 comments

53724 members

0 votes
95 views 1 comments
by
We can't figure out how to configure the RUT950 running on the new GUI (07.02.7) to use WLAN as WAN. There is not wlan0 interface selectable.

We did a workaround by downgrading to an older firmware that uses the old GUI. Configured the WLAN as WAN, saved settings and then upgraded again to 07.02.7 keeping the settings. After doing that, the router's interface list on the GUI showed a WWAN interface (type wireless). We can see in the settings that it uses wlan0 interface.

Question:

How can we setup WLAN as WAN on the new GUI?
by

Hello,

Please check this video: https://www.youtube.com/watch?v=INGKWNqnZZ0.

Make sure your router's LAN subnet is different than the access point's, to which you connect to.

Best regards,

1 Answer

+1 vote
by

Hello,

Thank you for contacting Teltonika Crowd support community.

To configure RUT950 WWAN you need to configure RUT950 as a client such that it can get internet access from another wireless device,

Kindly check the following link for a guide on how to do it. https://wiki.teltonika-networks.com/view/RUT950_Wireless#Client_Mode

For more clarification or technical support, kindly revert.

Kind regards,

Shadrack.

Best answer