Dear all,
I have the following question regarding RUT241 and the use of RMS. RMS is enabled for RUT241 device and works.
Current Configuration:
RUT241 PoE-Switch (TL-SG105PE) HKVision (DS-2CD1027G0-L) cam Huawei SmartLogger3000
LAN-Port ---->LAN-Port:3 (of Switch)
LAN-Port:1 (of Switch) ------------->PoE-LAN Interface (of Camera)
LAN-Port:4 (of Switch) -----------------------------------------------------------------> LAN-Port (of SmartLogger)
The IP address are configured (static) as:
RUT241: 192.168.1.1
TL-SG105PE Switch: 192.168.1.11
HKVision camera: 192.168.1.12
Huawei SmartLogger3000: 192.168.1.10
When I log into RMS, to to menu RMS Remote, select Remote HTTP(s), select the dropdown "remote" the command "Add new remote", within the modal window, in section "Device (Search Devices" i select the RUT241 device, then I click on "SCAN DEVICE", then I correctly receive a list of some "connected devices to RUT241".
I receive the following 192.168.1.11 and 192.168.1.10. And indeed I can add both devices. And for both devices I can create a "device remote access" and I can access the devices via RMS.
The question is, that I cannot see in the list the IP for SmartLogger (192.168.1.10) but RMS shows only for the Switch and HKVision Cam.
Keep in mind, I have not set up any port forwarding, so even for the Switch and HKVision there is no portforwarding, but still RMS can see them.
Can you please help? I would like to be able to access also the Huawei/Smartlogger?
Technical Information: RUT241-
Firmware version |
RUT2M_R_00.07.03 |
Firmware build date |
2022-12-15 13:53:43 |
Internal modem firmware version |
K |
Kernel version |
5.4.221 |
Thank you in advance!!
Kind regards,
Michael