Question

Hi, we are currently testing the NTRIP package on the RUT956 with FW RUT9M_R_00.07.03.2.

We are wondering if there is a way to output RTK data in CLI when NTRIP is enabled and connected? And also if it is possible to output the rs232 port so that when we have "Serial device" set for NMEA Source we can see the NMEA messages from the serial device?

Thanks in advance!

Regards,

Answer 1

Hello,

  

Currently, the only output from the NTRIP client can be seen by running the command /usr/sbin/ntrip_client -d /dev/rs232 or /usr/sbin/ntrip_client -d /dev/rs485. It looks like this:

As for outputting the data from the serial device, that will most likely not be possible. I do not have the necessary equipment to test it, so can't tell for sure, but if the commands mentioned above do not show anything useful then it is unlikely to be possible.

  

Best regards,
DaumantasG