Question

When wired LAN connection from the PC everythig works fine. But when i activate openVPN in trb140 software, it stops conneting to lan devices connected to the router. Via openVPN tunnel i can only ping or acces the router, not the lan connected divice.

Answer 1

Hello,

Is your TRB device configured as a server or a client?

Could you provide a topology of your network and details of your configuration?

Best regards,

Comments

it is configurated as a server. there is a trb router, and connected via Lan Schneider M251 controller. I need acces to the controller via OpenVpn tunnel.

There is a static ip on the router from SIM card provider.

OpenVpn tunnel is configured, and works fine, but i can not acces lan connected device, i can only acces the router.

---

I suggest to check the following link, specifically section Reaching a device's LAN network: https://wiki.teltonika-networks.com/view/OpenVPN_configuration_examples#Reaching_a_device.27s_LAN_network 

---

this is first thing i did before asking for help. I can give you remote acces via http to the router on PM. if it helps.

---

Could you attach a troubleshoot file to your question. Please, replicate the issue, then access router's WebUI, go to System -> Administration > Troubleshoot section and download troubleshoot file from there.

Files are private and visible only to Teltonika Moderators.

---

file added to main question

---

First, you need to change Virtual network IP address. It has to be within a private IP range but not the same as the current LAN network, for example 10.0.0.0.

Either client or server device needs to be on a different subnet. If your server's LAN is 192.168.1.1, change client's subnet to, for example,192.168.10.1.

If the server's IP is 192.168.1.0, the push option should be route 192.168.1.0 255.255.255.0. 

I have noticed that there are a lot of blocked IP addresses, who have tried to connect to your device remotely on port 22.

---

nothing helped. new troubleshoot file added for you to see

---

now i don't see device in ARPsection status Routes, ip and mac adress was shown before, now nothing.

---

Since your server's LAN is now 192.168.2.1, push option should be route 192.168.2.0 255.255.255.0.

---

done, still no acces to lan via OpenVPN

---

i can't eaven ping the router from lan connected m251 controller software, when openVPN is on, when its off the ping returns.

Answer 2

tried setting everything once again, still not working

Comments

Please delete client configuration instance on TRB device.

Could you also show .ovpn client configuration file from your PC?

---

client config delated. this is my client.ovpn file

---

is it ok? or maybe there is my problem?

---

Please help. Still no clue. i need this working

---

Got it. Everything works fine now. Problem was port forwording. I did it "upside down" this is why it dident worked.

It should be forworded from openvpn to Lan. My setting was from Lan to OpenVpn.